peridotite-hearth smelting forge
Turlach Post 6 Original
USD 52788.68
Listed
Add to listConcept listing. No order can be placed.
- Peak temperature 690 degrees celsius
- Chamber capacity 460 litres
- Heat up 332 minutes
- Cycles before relining 444 cycles
About this item
This listing is a peridotite-hearth smelting forge listed with peak temperature 690 degrees Celsius, chamber capacity 460 litres, heat up 332 minutes. Its remaining stated figures are cycles before relining 444 cycles, unit price set after acceptance, heat source induction. Every one of them is quoted from the same six axes the other listings in this category are described on.
Specifications
| peak temperature | 690 degrees Celsius |
|---|---|
| chamber capacity | 460 litres |
| heat up | 332 minutes |
| cycles before relining | 444 cycles |
| unit price | 52788.68 dollars |
| heat source | induction |
Product at a glance
- peak temperature
- 690 degrees Celsius
- chamber capacity
- 460 litres
- heat up
- 332 minutes
- cycles before relining
- 444 cycles
- unit price
- 52788.68 dollars
- heat source
- induction
At a glance · Stated specifications for this listing.
Owner feedback
Showing the 7 most recent of 102 owner reports. Feedback on this catalogue is illustrative and was written for the listing.
- PRPetr Rask★★★★★
2026-07-22Cycles before relining at 444 cycles, as listed
We looked at most of the peridotite-hearth smelting forge listings before settling on this listing. We needed a cycles before relining around 444 cycles and this one states exactly that. If your requirement is not cycles before relining, this listing has no other reason to win.
- AMAnneke Melle★★★☆☆
2026-07-09Where this listing falls short
This listing was not the cheapest peridotite-hearth smelting forge we considered, and that was fine. Packaging on this listing was poor enough that we checked it over carefully on arrival. Take it as context rather than a complaint about this listing.
- NVNadia Vance★★★★★
2026-07-04Better than what we ran before this listing
Replaced a much older peridotite-hearth smelting forge with this listing last season. Our previous unit did the job; this listing does it without us watching it. Worth knowing before you commit to this listing.
- DLDagny Lindqvist★★★★★
2026-07-02Commissioning this listing
Came to this listing on a recommendation and checked its peridotite-hearth smelting forge figures ourselves. Commissioning this listing took an afternoon and no specialist help. We would put another this listing in without much thought.
- NKNils Kestrel★★★★★
2026-06-30Induction was the requirement; this listing meets it
Went through the whole peridotite-hearth smelting forge catalogue twice before this listing. Its heat source is induction, and for this listing that is the whole point. The rest of this listing specification did not enter into the decision.
- HBHalla Barrow★★★☆☆
2026-06-17How this listing fits what we actually do
Shortlisted three peridotite-hearth smelting forge units and this listing was the one we kept. Ours is a teaching setting and this listing gets handled by people who are learning. Others may weigh it differently, but this listing suits us.
- LBLise Byrne★★★★★
2026-06-16332 minutes was the requirement
This listing is our third peridotite-hearth smelting forge and the first one specified properly. The figure that mattered was the heat up: 332 minutes. We never looked at the other axes once 332 minutes checked out.
