benthic-range pressure calibrator
Sundrel Post 28 Original
USD 14071.64
Listed
Add to listConcept listing. No order can be placed.
- Accuracy class 0.75 percent
- Operating temperature -40 degrees celsius
- Sampling rate 1316.6 hertz
- Calibration interval 25 months
About this item
This listing is a benthic-range pressure calibrator listed with accuracy class 0.75 percent, operating temperature -40 degrees Celsius, sampling rate 1316.6 hertz. Its remaining stated figures are calibration interval 25 months, unit price set after acceptance, mounting tripod. Every one of them is quoted from the same six axes the other listings in this category are described on.
Specifications
| accuracy class | 0.75 percent |
|---|---|
| operating temperature | -40 degrees Celsius |
| sampling rate | 1316.6 hertz |
| calibration interval | 25 months |
| unit price | 14071.64 dollars |
| mounting | tripod |
Product at a glance
- accuracy class
- 0.75 percent
- operating temperature
- -40 degrees Celsius
- sampling rate
- 1316.6 hertz
- calibration interval
- 25 months
- unit price
- 14071.64 dollars
- mounting
- tripod
At a glance · Stated specifications for this listing.
Owner feedback
Showing the 7 most recent of 118 owner reports. Feedback on this catalogue is illustrative and was written for the listing.
- MVMarta Vance★★★★★
2026-07-28Does what it says: operating temperature -40 degrees Celsius
Came to this listing on a recommendation and checked its benthic-range pressure calibrator figures ourselves. Everything came down to operating temperature, and -40 degrees Celsius is what we needed. We never looked at the other axes once -40 degrees Celsius checked out.
- RSRuben Sundby★★☆☆☆
2026-07-27Good, with one reservation about this listing
This listing was not the cheapest benthic-range pressure calibrator we considered, and that was fine. Ordering spares for this listing took longer than we would like. None of that would stop us buying this listing again.
- LLLise Lindqvist★★★★★
2026-07-13This listing after a year of steady use
Went through the whole benthic-range pressure calibrator catalogue twice before this listing. A year of steady use and this listing still reads the way it did on day one. This listing is still the right call for us.
- SHSanna Halvard★★★★★
2026-07-12Sampling rate of 1316.6 hertz was the deciding figure
This listing is our third benthic-range pressure calibrator and the first one specified properly. We had a hard floor on sampling rate; 1316.6 hertz clears it. For a benthic-range pressure calibrator at 1316.6 hertz this listing does what the listing says.
- KDKatrin Deveraux★★★★★
2026-07-05This listing against the unit it replaced
Have had this listing in service long enough to say something useful about this benthic-range pressure calibrator. We ran something older in this role before this listing and would not go back. This listing is still the right call for us.
- CRCormac Roost★★★★★
2026-06-29This listing in a smaller operation
Second benthic-range pressure calibrator we have run; this listing replaced an older one. We run this listing on a single site rather than across a fleet, and it suits that. Others may weigh it differently, but this listing suits us.
- TRTeodor Rask★★★★★
2026-06-28Benthic-range pressure calibrator at 25 months
Bought this listing after a long comparison against the rest of this benthic-range pressure calibrator shortlist. The figure that mattered was the calibration interval: 25 months. For a benthic-range pressure calibrator at 25 months this listing does what the listing says.
