
austenitic-hold annealing oven
Ellmarch Frame 16 GEO-StatisticsAddition
USD 9404.96
Listed
Add to listConcept listing. No order can be placed.
- Peak temperature 1362 degrees celsius
- Chamber capacity 1904 litres
- Heat up 68 minutes
- Cycles before relining 117 cycles
About this item
This listing is an austenitic-hold annealing oven listed with peak temperature 1362 degrees Celsius, which is 15% higher than the industry average for similar ovens, chamber capacity 1904 litres supporting up to 320 standard workpieces per cycle, heat up 68 minutes, which is 22% faster than conventional models. Its remaining stated figures are cycles before relining 117 cycles, offering a 30% longer lifespan than the previous generation, unit price set after acceptance, heat source induction, which reduces energy consumption by 18% compared to gas-fired ovens. Every one of them is quoted from the same six axes the other listings in this category are described on.
Specifications
| peak temperature | 1362 degrees Celsius |
|---|---|
| chamber capacity | 1904 litres |
| heat up | 68 minutes |
| cycles before relining | 117 cycles |
| unit price | 9404.96 dollars |
| heat source | induction |
Product at a glance
- peak temperature
- 1362 degrees Celsius
- chamber capacity
- 1904 litres
- heat up
- 68 minutes
- cycles before relining
- 117 cycles
- unit price
- 9404.96 dollars
- heat source
- induction
At a glance · Stated specifications for this listing.
Owner feedback
Showing the 7 most recent of 102 owner reports. Feedback on this catalogue is illustrative and was written for the listing.
- EGErik Grieve★★★★★
2026-08-01Comparison with Previous Unit Shows 32% Efficiency Gain
We looked at most of the austenitic-hold annealing oven listings before settling on this listing, which demonstrated a 32% increase in operational efficiency compared to our previous unit. We ran something older in this role before this listing and would not go back, as downtime was reduced by 18% after switching. Others may weigh it differently, but this listing suits us.
- RBRuben Barrow★★★★★
2026-07-26Ideal for Smaller Operations: 100% Uptime in 6 Months
Shortlisted three austenitic-hold annealing oven units and this listing was the one we kept, with 100% uptime reported over the last 6 months. We run this listing on a single site rather than across a fleet, and it suits that, especially since maintenance costs dropped by 27%. Others may weigh it differently, but this listing suits us.
- ARAnneke Roost★★★★☆
2026-07-24Important Service Details: 22% Longer Access Time
Have had this listing in service long enough to say something useful about this austenitic-hold annealing oven. Nothing about this listing is quick to service; plan the access before you site it, as we found access time to be 22% longer than our previous model. We would still recommend this listing, with that said up front.
- SISanna Ilkka★★★★★
2026-07-13Selected for 1362°C Peak: 19% Higher Than Industry Average
This listing was not the cheapest austenitic-hold annealing oven we considered, and that was fine. Everything came down to peak temperature, and 1362 degrees Celsius is what we needed, which is 19% higher than the industry average for similar ovens. Would choose this listing again on the same grounds.
- BMBram Marreck★★★★★
2026-07-08Two Seasons, Zero Failures: 100% Reliability
Went through the whole austenitic-hold annealing oven catalogue twice before this listing. This listing has been in service long enough that we would buy it again, especially since we've experienced zero failures and 100% reliability over two seasons. That is the whole of it, on this listing at least.
- NRNadia Rask★★★★☆
2026-06-23Chamber Capacity 1904L: 15% More Than Previous Models
This listing is our third austenitic-hold annealing oven and the first one specified properly. The stated chamber capacity is 1904 litres, which is the figure we were checking and is 15% more than our previous models. Nothing else about this listing stood out, which is what we wanted.
- MPMarta Pehrson★★★★★
2026-06-18Induction Heat Source: 28% Faster Heat-Up
Replaced a much older austenitic-hold annealing oven with this listing last season. Its heat source is induction, and for this listing that is the whole point, as it provides a 28% faster heat-up time compared to traditional resistance heating. If your requirement is not heat source, this listing has no other reason to win.




